John Deere 1040

On certain side-by-side UTVs, the owner's manual is missing information for how a person can contact Transport Canada to report a safety concern. Canadian regulations require all companies to provide this information in the owner's manual.

On certain side-by-side UTVs, the owner's manual is missing information for how a person can contact Transport Canada to report a safety concern. Canadian regulations require all companies to provide this information in the owner's manual.

On certain side-by-side UTVs, the owner's manual is missing information for how a person can contact Transport Canada to report a safety concern. Canadian regulations require all companies to provide this information in the owner's manual.

Scaffold record for tractor recall ingestion. Replace with a real safety notice source when available.

This recall involves 1023E, 1025R and 2025R Compact Utility Tractors with the model number and "John Deere" printed on the hood. The recalled tractors are green and yellow, and were sold with both opened and closed operator stations. The serial numbers of tractors included in this recall can be found at www.deere.com. Click on "Parts & Service" and scroll to "Recall" or go to www.deere.com/en/parts-and-service/recall-information/. The serial number is located on the frame, on the front right side of the tractor, near the engine.

Hi everyone, I have a John Deere 940 tractor (similar to the 1040) and I need some help identifying a part I found. I opened a plug in order to clean the mesh screen. The plug/hole is located under the transmission. After removing the mesh, I discovered a loose metal pipe inside the hole. Details: Pipe diameter: about 0.39 inch Length: about 7.9 inches One end has a 45° angle Other end has a 90° angle The pipe is loose inside and I cannot take it out because of its shape See attached images My questions: 1.What is this metal pipe? 2.What is its purpose? 3.Is it normal for it to be loose? 4.Should it be connected somewhere, and if yes, how? I want to make sure nothing is damaged or disconnected before I close everything back.

I need some help, I have a JD1040 2WD tractor 1980. My problem is that she blows the seal in the lift/hydraulic pump. I had the pump seal professional replaced and put everything back as they were with fresh hydraulic fluid. I started up the tractor and after a few minutes it started leaking fluid through the new seal. Some people told me that the release valve might be stuck, my problem is I don't know where the release valve is in this tractor. Any help or advice would be appreciated. Many thanks.

I need some help, I have a JD1040 2WD tractor 1980. My problem is that she blows the seal in the lift/hydraulic pump. I had the pump seal professional replaced and put everything back as they were with fresh hydraulic fluid. I started up the tractor and after a few minutes it started leaking fluid through the new seal. Some people told me that the release valve might be stuck, my problem is I don't know where the release valve is in this tractor. Any help or advice would be appreciated. Many thanks.